Article ID: 000034272 Content Type: Error Messages Last Reviewed: 06/30/2023

Intel® Optane™ Memory and Storage Management Application Shows Message "At risk (SMART event)"

Environment

Windows 11, 64-bit*, Windows® 10, 64-bit*

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Summary

Explains "At risk (SMART event)" pop-up message from the Intel® Optane™ Memory and Storage Management application.

Description
  • SATA SSD connected to a certain controller and a certain port is presenting problems and indicating an SMART event. For example, SATA SSD on Controller 0, Port 2: At risk (SMART event).
  • Intel® Optane™ Memory showing error At risk (SMART event).
  • Error message reported: Attention Required: One of your disks is at risk (SMART event). Please open Intel® Optane™ Memory and Storage Management application for details.
Resolution

The message is informing the user that a potential problem has been detected in the Solid-State Drive (SSD), the Intel® Optane™ Memory or the application, and how it communicates with the system.

This notification is typically the result of a standard health monitoring system (SMART) that may have detected an issue with a storage device in the system being managed by the Intel® Rapid Storage Technology (Intel® RST) driver/controller. It could also be the application not being able to detect RAID or Intel® Optane Memory volumes it was expecting.

Before you continue reading

Read through all of the tips below before proceeding:

  • For SSDs and HDDs:

    • Some system and SSD manufacturers have included an option to test and fix SSD integrity.
  • For Intel® Optane™ Memory:

    1. Next to the message At risk (SMART event) is a hyperlink in parentheses, Suppress SMART. Clicking this option will disable the Intel® Optane™ Memory.
    2. Once the Intel® Optane™ Memory is disabled access Command Prompt and clean the Intel® Optane™ Memory.
      1. Open an Administrator Command Prompt. (Click on the start menu icon, type Command Prompt and select Run as administrator).
      2. Type diskpart and press Enter.
      3. Type list disk to display a list of your connected storage devices. Here you should be able to see the Intel Optane memory module. Note the disk number.
      4. Type Select Disk # and press Enter. Make sure to adjust to match the disk number displayed for your module.
      5. Type Clean and press Enter. Diskpart will proceed to low-level format the memory module. Once the command completes the command prompt may be closed.
    3. Reboot the system, access again the Intel® Optane Memory and Storage Management application and enable the Intel® Optane™ Memory.