HDMI Intel® Arria 10 FPGA IP Design Example User Guide

ID 683156
Date 7/29/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

4.3.1. Set Up the Hardware

The first stage of the demonstration is to set up the hardware.

When SUPPORT FRL = 0, follow these steps to set up the hardware for the demonstration:

  1. Connect the Bitec HDMI 2.0 FMC daughter card (revision 11) to the Arria 10 GX development kit at FMC port B.
  2. Connect the Arria 10 GX development kit to your PC using a USB cable.
  3. Connect an HDMI cable from the HDMI RX connector on the Bitec HDMI 2.0 FMC daughter card to an HDCP-enabled HDMI device, such as a graphic card with HDMI output.
  4. Connect another HDMI cable from the HDMI TX connector on the Bitec HDMI 2.0 FMC daughter card to an HDCP-enabled HDMI device, such as a television with HDMI input.
When SUPPORT FRL = 1, follow these steps to set up the hardware for the demonstration:
  1. Connect the Bitec HDMI 2.1 FMC daughter card (Revision 9) to the Arria 10 GX development kit at FMC port B.
  2. Connect the Arria 10 GX development kit to your PC using a USB cable.
  3. Connect an HDMI 2.1 Category 3 cables from HDMI RX connector on the Bitec HDMI 2.1 FMC daughter card to an HDCP-enabled HDMI 2.1 source, such as Quantum Data 980 48G Generator.
  4. Connect another HDMI 2.1 Category 3 cables from the HDMI TX connector on the Bitec HDMI 2.1 FMC daughter card to an HDCP-enabled HDMI 2.1 sink, such as Quantum Data 980 48G Analyzer.