Visible to Intel only — GUID: wtw1459321667484
Ixiasoft
ED810X+FDMF5820 Kit
Figure 8. ED810X+FDMF5820 Kit
Figure 9. ED810X+FDMF5820 Jumper
ED810X+FDMF5820 Kit Setup Instructions
To set up the ED810X+FDMF5820 kit, follow these steps:
- Connect all the jumpers as shown in the ED810X+FDMF5820 Jumper figure.
- Solder 1-kΩ resistors on SDA, SCL, and SMBALERT lines. You are only required to perform this step on the first ED810X+FDMF5820 kit connected in a daisy-chain connection.
- Solder R22 and R23 with the correct resistor value to set the PMBus address for each power module.
- Connect the jumper to J7 as shown in the ED810X+FDMF5820 Jumper figure.
- To set the desired voltage, refer to the FDMF5820 Kit User Guide.
This design example uses the following PMBus address for the power modules.
Group | Nominal Value (V) | R22(kΩ) | R23(kΩ) | PMBus Address (HEX) |
---|---|---|---|---|
1 | 0.9 | Short | 3.3 | 0x20 |
2 | 1.8 | Short | 5.6 | 0x30 |
3 | 1.8 | Short | Short | 0x40 |
Related Information