AN 699: Using the Altera Ethernet Design Toolkit

Download PDF
ID 683469
Date 5/13/2016
Public
Document Table of Contents
Document Table of Contents x
1. Using the Altera Ethernet Design Toolkit
1. Using the Altera Ethernet Design Toolkit x
1.1. Features 1.2. Hardware and Software Requirements 1.3. Getting Started 1.4. AN 699 Document Revision History
1.3. Getting Started x
1.3.1. Configuring the FPGA and Clock 1.3.2. Launching the Ethernet Design Toolkit 1.3.3. Recommended Flow for Using the Ethernet Design Toolkit
1.3.3. Recommended Flow for Using the Ethernet Design Toolkit x
1.3.3.1. Ethernet Design Toolkit Tabs and Settings
1.3.3.1. Ethernet Design Toolkit Tabs and Settings x
1.3.3.1.1. IP Configuration Tab 1.3.3.1.2. IP Status Tab 1.3.3.1.3. Traffic Controller Tab
1. Using the Altera Ethernet Design Toolkit

1.3.3. Recommended Flow for Using the Ethernet Design Toolkit

  1. Configure the MAC and PHY IP core.
  2. Check the MAC and PHY status to verify that the system is ready for traffic.
  3. Configure the Traffic Controller Generator Module and start traffic transmission.
  4. Check the Traffic Monitor module for information on the received data.
  5. For debugging purposes, check the MAC statistics counter for the transmitted and received packets condition after traffic stops.

Section Content
Ethernet Design Toolkit Tabs and Settings

Level Two Title