Intel® Stratix® 10 Configuration User Guide

ID 683762
Date 10/21/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.1.7.4.4. PFL II IP Recommended Constraints for Other Input Pins

Set a false path for PFL II IP input pins

You can set the pfl_nreset input reset pin to a false path since this pin is asynchronous.

set_false_path -from [get_ports {pfl_nreset}] -to *

Set input delay to PFL II IP input pins

Example below sets the input delay for the pfl_flash_access_granted pin.
  • You don't have to constraint the path when you use the device arbiter logic to control the pin,
  • You don't have to constraint the path when not using the device arbiter logic or the external processor to control the pin and you loopback the pfl_flash_access_request signal to the pfl_flash_access_granted pin.
  • You can constraint the path when a processor or an external device controls the pfl_flash_access_granted pin.
set_input_delay -clock {clk_50m_sysmax} -max [<pfl_flash_access_granted_tco_max> + <pfl_flash_access_granted_tracemax>] [get_ports {pfl_flash_access_granted}]
set_input_delay -clock {clk_50m_sysmax} -min [<pfl_flash_access_granted_tco_min> + <pfl_flash_access_granted_tracemin>] [get_ports {pfl_flash_access_granted}]

Set a false path for fpga_pgm[] input pin

You can set a false path to quasi-static signals such as reset and configuration signals (fpga_conf_done, fpga_nstatus) that are stable for a long periods of time.

set_false_path -from [get_ports {fpga_pgm[]}] -to * 

Set input delay to pfl_nreconfigure input pin

If you use the external component to drive this pin, you must set the input delay path to drive the pfl_nreconfigure pin.

set_input_delay -clock {clk_50m_sysmax} -max [<pfl_nreconfigure_tco_max> + <pfl_nreconfigure_tracemax>] \
[get_ports {pfl_nreconfigure}]

set_input_delay -clock {clk_50m_sysmax} -min [<pfl_nreconfigure_tco_min> + <pfl_nreconfigure_tracemin>] \
[get_ports {pfl_nreconfigure}]

Set input delay to pfl_reset_watchdog pin

If you use the external component to drive this pin, you must set the input delay path to drive the pfl_reset_watchdog pin.
set_input_delay -clock {clk_50m_sysmax} -max [$pfl_reset_watchdog_tco_max + $pfl_reset_watchdog_tracemax] \
[get_ports {pfl_nreconfigure}]

set_input_delay -clock {clk_50m_sysmax} -min [$pfl_reset_watchdog_tco_min + $pfl_reset_watchdog_tracemin] \
[get_ports {pfl_nreconfigure}]