External Memory Interface Handbook Volume 1: Intel® FPGA Memory Solution Introduction and Design Flow: For UniPHY-based Device Families

Download PDF
ID 710283
Date 3/06/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction to this Handbook 2. Recommended Design Flow 3. Selecting Your Memory 4. Selecting Your FPGA Device
1. Introduction to this Handbook x
1.1. Introduction to Memory Solutions 1.2. Protocol Support Matrix 1.3. Document Revision History
2. Recommended Design Flow x
2.1. Getting Started With External Memory Interfaces 2.2. Document Revision History
2.1. Getting Started With External Memory Interfaces x
2.1.1. Selecting Your External Memory Device 2.1.2. Selecting Your FPGA 2.1.3. Planning Your Pin Requirements 2.1.4. Planning Your FPGA Resources 2.1.5. Determining Your Board Layout 2.1.6. Specifying Parameters for Your External Memory Interface 2.1.7. Performing Functional Simulation 2.1.8. Adding Design Constraints 2.1.9. Compiling Your Design and Verifying Timing 2.1.10. Verifying and Debugging External Memory Interface Operation
3. Selecting Your Memory x
3.1. DDR SDRAM Features 3.2. DDR2 SDRAM Features 3.3. DDR3 SDRAM Features 3.4. QDR, QDR II, and QDR II+ SRAM Features 3.5. RLDRAM II and RLDRAM 3 Features 3.6. LPDDR2 Features 3.7. Memory Selection 3.8. Example of High-Speed Memory in Embedded Processor 3.9. Example of High-Speed Memory in Telecom 3.10. Document Revision History
4. Selecting Your FPGA Device x
4.1. Memory Standards 4.2. I/O Interfaces 4.3. Wraparound Interfaces 4.4. Read and Write Leveling 4.5. Dynamic OCT 4.6. Device Settings Selection 4.7. Document Revision History
4.6. Device Settings Selection x
4.6.1. Device Speed Grade 4.6.2. Device Operating Temperature 4.6.3. Device Package Size 4.6.4. Device Density and I/O Pin Counts
1. Introduction to this Handbook
2. Recommended Design Flow
3. Selecting Your Memory
4. Selecting Your FPGA Device

2.1.4. Planning Your FPGA Resources

Before you can specify parameters for your external memory interface, you must determine the FPGA resource requirements. The FPGA resources required by your design depend on many factors, including the memory interface frequency, timing requirements, and the IP that your design uses.
  1. Determine the PLLs and clock networks that your design requires.
  2. If multiple PLLs are required for multiple controllers that cannot be shared, ensure that enough PLL resources are available within each quadrant to support your interface number requirements.
  3. Determine whether cascading of PLLs is appropriate for your design.
  4. Determine the appropriate DLL usage for your design. If multiple external memory interfaces must share DLL resources, ensure that the frequency and mode requirements are compatible.
  5. Determine the registers, memory blocks, OCT blocks, and other FPGA resources required by your design.
Related Information
Level Two Title