Arria V Hard Processor System Technical Reference Manual

ID 683011
Date 12/02/2022
Public
Document Table of Contents

11.4.12. Debug Resets

The CoreSight* system uses several resets.

Table 79.   CoreSight* Resets

Arm* Reset Name

Clock Source

HPS Reset Signal Name

Description

ATRESETn

Reset manager

dbg_rst_n

Trace bus reset. It resets all registers in the ATCLK domain.

nCTIRESET

Reset manager

dbg_rst_n

CTI reset signal. It resets all registers in the CTICLK domain. In the HPS, there are four instances of CTI. All four use the same reset signal.

DAPRESETn

Reset manager

dbg_rst_n

DAP internal reset. It is connected to PRESETDBGn.

PRESETDBGn

Reset manager

dbg_rst_n

Debug APB* reset. Resets all registers clocked by PCLKDBG.

HRESETn

Reset manager

sys_dbg_rst_n

SoC-provided reset signal that resets all of the AMBA* on-chip interconnect. Use this signal to reset the DAP AHB* -Lite master port.

PRESETSYSn

Reset manager

sys_dbg_rst_n

Resets system APB* slave port of DAP.

nCTMRESET

Reset manager

dbg_rst_n

CTM reset signal. It resets all signals clocked by CTMCLK.

nPOTRST

Reset manager

tap_cold_rst_n

True power on reset signal to the DAP SWJ-DP. It must only reset at power-on.

nTRST

JTAG interface

nTRST pin

Resets the DAP TAP controller inside the SWJ-DP. This signal is driven by the host using the JTAG connector.

TRESETn

Reset manager

dbg_rst_n

Reset signal for TPIU. Resets all registers in the TRACECLKIN domain.

The ETR stall enable field (etrstallen) of the ctrl register in the reset manager controls whether the ETR is requested to stall its AXI* master interface to the L3 interconnect before a warm or debug reset.

The level 4 (L4) watchdog timers can be paused during debugging to prevent reset while the processor is stopped at a breakpoint.